The spa/pool is an in-ground type. After a complete filtering cycle, the water level is where it should be about an inch or so above the tile and plaster line. But, after a few hours, the water level drops to 5 to 6 inches below the line.

After 30 minutes, the blower to the spa shut off automatically. I reviewed the pool programs from the control box inside my house and saw that this was supposed to happen. However, now the water in my spa is draining into my pool (I can feel the suction coming from the intake/outake valves on the sides of the spa). I tried refilling the spa twice already from the outside control panel (by turning on the filter and "spa fill" controls, as instructed by the conntrol panel that is attached to my house beside my pool. However, each time I did this, the spa filled to the level I wanted it filled to, but then started to drain again once I turned the "spa fill" feature and filter off. It’s a slow drain, but a drain nevertheless. Any ideas on why this is happening and how can I stop it so the water level in the spa will remain above the intake/outake valves……..or better yet, remain at the top of the spa where I like it?

Both pool and spa are filled nicely with the correct amount of water. My problem occurs when the system is turned off, at which time the spa water drains down and the pool water level increases. I think perhaps some of the valve switches are incorrectly set allowing the spa water to be fed back into the pool,but I’m not sure. How should the valves be set? Or is there some other reason? I’ll appreciate any answer. Thanks.

I have a spa connected to a pool, but the spa seems to be draining to pool water level everytime the pumpo shuts down. The water from the spa seems to be going back to the pool!

I have tried taking water out of the spa so the water level could be below the pool, but then the pool starter draining to the spa, until they both reached the same level!

There are no leaks, and i have tried closing and opening all the valves that control the pool, i have tried filling the spa with water, but then the spa drains to the pool until they reach the same water level, even with the pump completely shut down.

I don’t know what to do, and it wasn’t like this before… the water from the spa used to be much higher than the pool water level.

Anyone knows how to fix this? I don’t wanna spend any money right now, so if anyone that know about pools has any ideas, i would appreciate it!

the only valves that control my pool, are: spa drain, main drain, skimmer, floor system, spa spillover!
*here’s also a valve that control a jet on the side of the pool!

*sry about the misspellings!

Jacuzzi heater and piping is all brand new, works fine all the time, this time i tried to use it, it worked fine, the water got too low i think in the spa so it just stopped filtering all together but the heater and filtering system was still on and working, just not getting to the spa. i filled it back up, flipped on the switch to get the water filtering and have the heated water going into it, but now i turn the switch on the system is working (heater unit and piping), but the water isnt getting to the spa at all, but it still sucks the water in from the spa (when the the switch is on). how do i get it to work like a spa again? all that happened was that the water level was too low then it basically shut off the water supply to the spa, but the heater unit and water switch was still on. thanks in advance.

I just emptied out my hot tub for the first time and am planning on re-filling it. How much water should be in the spa? Should the water level cover up the filter entirely?

Spa is full and has the flow over the wall working while the pump is running. Once the pump stops running, the spa drains about 1/2 way down. What would cause that? My spa has always maintained a full water level until just recently.