Ok, we just bought a used softub that has a gfci plug. Put it together, filled it up (no leaks), plugged it in & have a power light on the gfci, but no power at the pump or control panel. It's an older model that only has the 3 lights - 1 each for jets, heating, & power.

Troubleshooting guide says for the gfci to work right, the outlet must be wired correctly... but I get a light on the gfci plug - does that mean it's ok?

I'm thinking if it's not the wiring at the gfci plug, then it has to be in the pump assembly itself.

Anyone else run across this problem before or are there typical issues with the softubs?

Thanks !
as far as wiring - all softubs run off a standard 15a circuit - normal grounded plug in. therefore, no need for special wiring.

regarding the grounding, it was too late by the time I asked, I will get a electrical outlet checker tomorrow.